Standing seam and metal panel roofing, roof repair and full replacement in Hemet. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Hemet.
A coating buys real years on the right roof and wastes money on the wrong one. We will tell you honestly which kind you are looking at.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Standing seam and metal panels have been our specialty since 2002. Around Hemet that means everything from a small porch roof to a full house in dark green, burgundy or bronze, cut and fit on site by crews who have done hundreds of them.
A metal roof done right in Hemet should be quiet inside, straight from the street, and still there long after you have stopped thinking about it. That takes sound decking, real underlayment, and panels that are actually square. We do not skip those parts to save a day.
Here is what Hemet homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
Often, yes. Plenty of the Hemet roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Plenty of them. Most Hemet customers choose from around twenty standard colors, and green, burgundy, bronze, black, gray, tan and barn red are the ones people pick most. We bring the color chart out with the estimate so you can hold it up against your siding.
A typical Hemet shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Hemet houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Sometimes. If the decking is sound and there is only one layer of shingles, a Hemet metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Hemet ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Real feedback from homeowners whose roofs we have worked on.
"Called about shingles that blew off in a storm. They were out the next morning, patched it, and would not take a dime more than what the estimate said."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."
Our crews cover the surrounding area, not only the city limits.